Technical drawings. General principles of presentation - Sections on mechanical engineering drawings Ingestion-build-48348

Technical drawings. General principles of presentation - Sections on mechanical engineering drawings Ingestion-build-483481 Scope This part of ISO 128 specifies general principles for presenting sections on mechanical engineering drawings following the orthographic projection methods specified in ISO 5456 2. For areas on sections, representation is according to ISO 128 50[1]. Attention has also been given to the requirements of reproduction, including microcopying in accordance with ISO 6428. NOTE The basic rules for cuts and sections are given in ISO 128 40[2].

dynamic strength implementing the maximum rated load for lanyards

— pre-cooling device

The service interface parameters

BS 2090 provides detailed guidance on the dimensions and tolerances for hook spanners

Guidance for the development of in vitro test methods is included in an informative annex to this document

PD CEN/TR 16988 is about the estimation of uncertainty in the single burning item test

and health and performance management of system components

a part of the BS 1722 series

as the single clause is applicable to any of the above frequency ranges

— maintenance documentation describing the internal operation of systems software

ISO 21105‑1 applies to new building construction and building re-commissioning

This document specifies four methods for the determination of the density of carbon fibre tested as a yarn: