Test conditions for numerically controlled turning machines and turning centres - Evaluation of thermal distortions Ingestion-build-209208

Test conditions for numerically controlled turning machines and turning centres - Evaluation of thermal distortions Ingestion-build-2092081 Scope This part of ISO 13041 specifies, with reference to ISO 230 3, the tests which apply for the evaluation of thermal distortions of the machine structure and positioning system, up to 2 000 mm in length, of numerically controlled (NC) turning machines and turning centres. Hence, this part of ISO 13041 defines three tests which are the environmental temperature variation error test, the test for thermal distortion caused by a rotating spindle,

Addition of steel grades E460

NOTE: This standard is the British equivalent of ISO 2859-1 1999

Why should you use ISO 5952 - Steel sheet

BS EN 50377-8-13 also described the dimensional requirements of the connector along with its test procedures needed for the termination on IEC 60793-2-50 category B1

the execution provisions are given in EN 1090–2

provided the size of the person’s body (as indicated by the specified dimensions) has been determined

Pigment glands in cotton stems

Requirements for alarm transmission systems using dedicated alarm transmission paths

it is divided into the plain weave

materials and construction requirements for medicine trolleys suitable for use in hospitals

Contents of BS EN ISO 14630 include:

– power transformers